![]() Not had my other one on test yet to see if its normal as its in a rack and all wired up and didn't want to pull it all apart until the replacement is ready to go in. If its not ok and help with what to change to fix it would be appreciated. If so are my readings acceptable, am I just being paranoid now I can measure the output. ![]() II (FEDGEN) Yamaha CA-2000 (DimasAtl) Yamaha AX-592. I can't find any pot to adjust the channel bias so assume its fixed. Yamaha aes rs7 electric guitars service manual Guitarra Yamaha AES 620 HB en. Looking at the scope throughout the volume range there is a tiny difference between left and right comparing the trace overlaid with each other. Output at just before clipping of a 1 Kh Sine wave Tone with amp connected to 8 ohm Dummy Load The readings I am getting are not quite right but don't know if its normal or not or am I just being paranoid Power Output: 100W into 8 (stereo) Frequency Response: 20Hz to 20kHz Distortion: 0.008 Damping Factor: 320 Speaker Impedance: Input Sensitivity: 2.5mV (mm. Today I thought I would do some measurments to check all is well before I replace my other AX-592 that has the common faulty mode selector switch ![]() I have done all basic stuff like blowing the dust out and deoxing all the pots and switches and it seems to work fine. View and download the pdf, find answers to frequently asked questions and read feedback from users. I am looking for some advice on my new to me Yamaha AX-592
0 Comments
Leave a Reply. |